The “5 min read” label on an article is calculated with one division: words ÷ reading speed. The only real question is which speed to use.

Where the numbers come from

For decades, articles and tools repeated figures of 200, 250 or even 300 words per minute, often without a source. In 2019, the psychologist Marc Brysbaert published a review combining 190 studies of reading speed with 18,573 participants. His estimates for adults reading English silently were about 238 words per minute for non-fiction and about 260 for fiction. Reading aloud was considerably slower, at about 183 words per minute (based on 77 studies).

TexaDocBase uses 238 as its default reading speed because it has a documented basis. The round numbers are not wrong, just planning figures.

Why real reading times vary so much

Individual speeds vary widely around any average. Speed also changes with:

  • Purpose: skimming for the gist is much faster than studying for detail.
  • Difficulty: unfamiliar vocabulary, dense argument and technical notation all slow readers down.
  • Language: speeds in words per minute differ between languages, partly because words differ in length.
  • Medium: small screens, poor contrast and long lines can slow reading.

An estimate describes a typical reader in typical conditions. It is a courtesy to readers, not a promise.

The calculation

minutes = words ÷ words per minute

For 1,800 words at 238 wpm: 1,800 ÷ 238 = 7.56 minutes, or about 7 minutes 34 seconds, usually shown as “8 min read”.

Most sites round to the nearest minute and never show less than one. Some also add a few seconds for each image.

Choosing a rate

  • General articles for adults: 230–250 wpm.
  • Technical documentation, legal or academic text: 150–200 wpm.
  • Children or language learners: lower still; measure if you can.
  • Content meant to be skimmed: estimates matter less; readers set their own pace.

The Reading Time Calculator lets you set the rate and shows a 200–300 wpm range alongside the main estimate.